Follow these steps to connect your map to your WiFi Network (takes about 3 minutes)
Step 1: Connect to Your Computer
Plug the left USB-C connector into a USB-A on your computer using the supplied cable (some cables can be power only)
The left connector must be used for Wi-Fi setup but after that you can power the device from any of the USB connectors.
Step 2: Open Browser
Open Chrome or Edge
Firefox or Safari don’t work because the setup tool requires a browser that supports web-serial
Step 3: Open Setup Page
Select the Melbourne button → Click Connect
Step 4: Allow Serial Port Access
Click on your device and then click Connect in your browser’s pop-up to grant device access
If multiple devices appear, look for: USB JTAG/serial debug unit
Step 5: Configure WiFi
Click Change Wi-Fi in the pop-up window
Also note that you can update the firmware for new features by clicking Install LED-Rails Firmware
Step 6: Connect to Network
1. Select your WiFi network from the drop-down
2. Enter password
3. Click Connect
Stores the last 16 Wi-Fi networks – automatically connects to closest available!
